remove seats Ram 1500 2013 Get to Know Guide 

Installing The Lower Attachments:
• The vehicle lower anchorages are round bars located at the rear of the seat cushionwhere it meets the seatback. The rear seat lower anchors can be readily identified
by the symbol
located on the seatback directly above the anchorages and are
just visible when you lean into the rear seat to install the child restraint.
• Loosen the child seat adjusters on the lower straps and on the tether strap so
that you can attach the hooks or con-
nectors to the vehicle anchors more
easily.
• Attach the lower hooks or connectors over the top of the seatcover material.
• Then tighten the straps as you push the child restraint rearward and down-
ward into the seat.
Tether Anchorage Points At The Right And
Center Front Seat (Regular Cab - All Seats):
• Place the child restraint on the seat and adjust the tether strap so that it will reachover the seat back under the head restraint to the tether anchor directly behind the
seat.
• Lift the cover (if equipped), and attach the hook to the square opening in the
sheet metal.
• Install the child restraint and remove the slack in the tether strap according
to the manufacturer's instructions.
Child Restraint Installation Sequence
(Mega Cab® - Rear Seats):
• Place a child restraint on each out-board rear seat and adjust the tether
strap so that it will reach under the
head restraint to the tether anchor directly behind the seat.
• Lift the cover, and attach the hook to the square opening in the sheet metal.
• Install the child restraint and remove the slack in the tether strap according to the manufacturer's instructions.
Child Restraints Installation Sequence (Quad Cab®/Crew Cab - Rear Seats)
The top tether anchorages in this vehicle are tether strap loops located between the
rear glass and the back of the rear seat. There is a tether strap loop located behind
each seating position. Follow the steps below to attach the tether strap of the child
restraint.
GETTING STARTED
16

Memory Seat
• The memory seat feature allows you tosave the driver's seat position (exclud-
ing lumbar position), driver's outside
mirror position, adjustable brake and
accelerator pedals, Automatic Tem-
perature Control (ATC) temperature
setting and radio station preset set-
tings. The driver's memory buttons are
located on the outboard side of the
driver's seat cushion.
• Adjust all memory profile settings, press the middle button S (SET), then
press 1 or 2 within five seconds.
• To program a Key Fob to the memory position, place the ignition switch in the LOCK position and remove the Key Fob, press and release the LOCK button on the
Key Fob to be programmed within 5 seconds of pressing button 1 or 2.
• Press 1 or 2 to recall the saved positions, or press UNLOCK on the programmed Key Fob.
• Refer to the Owner's Manual on the DVD for further details.
Manual Seats
Forward/Rearward
• Lift up on the adjusting bar located at the front of the seat near the floor and
release it when the seat is at the de-
sired position. Then, using body pres-
sure, move forward and backward on
the seat to be sure that the seat adjust-
ers have latched.
Recliner
• Lift the recliner lever located on the
outboard side of the seat, lean back
and release at the desired position.
CAUTION!
Do not place any article under a power seat or impede its ability to move as it may
cause damage to the seat controls. Seat travel may become limited if movement
is stopped by an obstruction in the seat’s path.
GETTING STARTED
21